Dainese Todi Slim Jeans (SOLD OUT)

We measured a sampling of these jeans of different waist sizes and lengths and find they are much like other jeans you’d buy these days. They are just a bit “vanity” sized in the waist. Across the size run, the actual measured waist is just about 2” larger than the stated size which is typical vanity sizing. And of course these are denim and may shrink just a tad too. The jeans have pockets in the hips for the addition of the Pro-Shape hip protectors (see link below). The hip armor is quite thin and flexible so I don’t think they’ll make a difference in the size choice of jeans if you choose to wear them. So my overall advice would be to buy the waist size you normally wear in jeans; you’ll likely find a fit. If you aren’t sure whether your jeans are vanity sized like I’m describing, then either measure your waist where your normal jeans ride or measure your favorite pair of jeans to verify. You’ll probably find that you measure out a bit bigger than your normal jeans size and also the waist of your favorite jeans measures out an inch or two bigger than their stated size. If so, you will be on track following my advice.

The inseam lengths measured out to be average. In the smaller jeans, the inseam of about 32”, the mid-sized jeans were about 33.5” and the larger jeans topped out at about 35”. Again, the jeans will probably shrink a bit, but even so, these inseam measurements are generous. The pant legs are a simple design and could be hemmed.

Need help measuring? Get it here.

Dainese introduced two jean styles in 2017 that have very equal specs and vary only by fit. This the Todi jean which has a standard to slim seat and very tapered legs. The Tivoli jean is more of a straight cut jean. Both come with Kevlar reinforcement in the seat and hips and Pro Shape armor.

Those who want very skinny legs on a motorcycle riding pat will like these. The seat and waist have pretty good room… similar to several other jeans we’ve tried on from Dainese. The fly closure on these pants is a zipper where many of the other styles from Dainese are a button fly. The tailoring on the back pockets on this one is simple and without the black leather trim I’ve seen on other styles.

The armor installed in the knee pocket is the very thin flexible Pro-shape armor. Many jeans use this type of armor. Its think and of course isn’t going to be as impact protective as thicker armor, but with a jean, most people don’t want armor that show through the fabric, so than regard, this stuff is perfect, especially for a slim fitting jean like this. Thicker armor just wouldn’t fit without showing through. There are pockets at the hip that will accept matching hip armor. Just take the link below to purchase. Aside from the armor, the pants are reinforced in the seat hips with Kevlar fabric. Take a look at our “inside out” pic to see that.

The knee armor in this jean is positioned in a pocket where you can choose two different positions so you can get the armor placed well over your knee. The pants have a pretty long inseam and they intend for you to roll those up an inch or two because they’ve put reflective material on the underside of the fabric at the end of the leg. The fabric in these jeans has been pre-washed quite a lot and they are very flexible and comfortable. These will be great looking on or off the bike. :: Paul, 07-31-19