Biltwell Lane Splitter Or Gringo S Baseplate Kit
This is a replacement base plate kit for Biltwell Gringo S and Lane Splitter helmets. There are two parts that make up the base plate kit. These two parts fit behind the shield up next to the helmet to provide the ratcheting action when you raise and lower the shield.
Each Gen 1 base plate kit sold here will replace ONE base plate assembly for one side of your helmet. If you want to replace the base plate assembly on BOTH sides of the helmet, you need to order TWO of the Gen 1 kits.
This is a complete pair (four pieces total) of replacement baseplates for Gen 2 Biltwell Gringo S and Lane Splitter face shields. This kit will also allow you to fit a Gen 2 shield on any earlier Biltwell Gringo S or Lane Splitter helmets or is a direct replacement on Gen 2 helmets.
If you don’t know which generation you have, take a look at the instructions in the photos for details.
If you want the replacement washer and screw that secures the shield to the base plate kit, then take the link below to buy a “hardware kit”. They are offered in several colors. The hardware kit contains two screws and two washers, so you only need to order one kit to replace those parts on both sides of the helmet.
Fits Gringo S or Lane Splitter helmets.