Sidi Street Boots
- Low cut casual yet moto protective design
- Lorica outer construction
- Perforated Teflon treated nylon lining
- Composite inner sole
- Removable arch support
- Protective internal heel and toe cups
- Double stitched in all high stress areas
- Zipper-Velcro closure system
- Rear of boot heel pull tab for easy entry
- Lug sole
- Internal protective ankle ball pads
Please Note: We can ship Sidi products to US, US territory or APO/FPO addresses only (per manufacturer’s restrictions).
Read on for more details.
Sizing Information
Visit our Sidi Sizing Information page for complete size conversion info (ladies can use the chart at the bottom of the page).
The length of the Street boots seems to be comparable to other Sidi boots however we felt the foot/instep area was more roomy in these boots than other Sidi boots (which fit comparatively trim in that area). I’d compare the fit around the instep to that of an Oxtar, TCX, or Alpinestars which typically have more room.
Our Two Cents
The best way I can think to describe the Street boots by Sidi is that they are a short top engineer boot. The sole is very thick compared to other boots in their line-up. We often get asked about boots that will add some height and this would be a good one. At the heel, I get a thickness of about 1 1/4” and in the ball area about 1”. This boot features a nice breezy mesh type liner and a cushioned foot bed. They close with a simple side zip. There are internal ankle protectors on the inside and outside of the foot and the toe box area is heavily reinforced for shifting and for protection. We have a nice set of close-up pictures you can view by taking the “View Larger Images” link above.









