FirstGear Mesh Lo Boots - 2013

  • Mesh upper
  • Lace-up fit with hook-and-loop ankle strap
  • Hard ankle and toe box protection
  • Toe shift patch

Tweet_button Share this page on Twitter!

$5 Promotional Gift Card available on this product!
$5.00
Purchase this product and receive a promotional gift card!
Read on for more details.
 
Free Shipping on All Orders over $89!
MSRP:
$109.95
,  Our Price:
$98.95

Sizing Information

FirstGear sells these boots in US sizes. In trying them on, we found the boots to run about one size small in the larger sizes and about a half size small in the smaller size range. We therefore recommend that you use our chart to make a selection (see below).

For each boot size, there is a European size printed in each boot also. The European sizes listed seem to be a good estimate of fit, so if you know your Euro size in most boots, then use our chart to select the “FirstGear Boot Size” based on your usual Euro size.

Why is this sorta messed up? Well, I asked FirstGear, but didn’t get a response. My personal guess is that FirstGear bought these boots from a manufacturer that was used to making boots in European sizes, but then FirstGear decided to sell them in US shoe sizes, and unfortunately they messed up the Euro to US conversion. In any case, just choose by the sizing advice we give and you should be fine.

FirstGear
Boot Size
Our Estimate of
How They Fit
European Size
Labeled in the Boots
8 7.5 41
9 8.5 42
10 9.5 43
11 10 44
12 11 45
13 12 46

The width of these boots tends toward roomy. Some brands like Sidi and Tour Master are more narrow, perhaps a C or D width, and I’d estimate the width of these FirstGear boots as slightly more wide, say D or E. Other brands that run wider like these FirstGear boots are TCX and Alpinestars.

Our Two Cents

A lot of people like a hiker-style boot for riding, and this one is specifically built for those people and for hot weather use. The Mesh Lo boot is a combination of leather and mesh which will allow a lot of air flow. The height of the boot covers the ankle bones (a minimum design feature in my opinion for a protective style), and to provide some impact protection there are integral plastic impact pieces fitted on either side of the ankle. You can see where those are secured by stitching in the close up pictures (the circle on either side). The heel area and toe box is reinforced. There is a layer of rubber-like material over the toe to firm up the boot where you shift (and to protect the boot from wear). The sole is a typical firm rubber design. A lace boot like this gives a lot of adjustability for fit and the laces are kept in check with the loop eyelets and the little Velcro-close strap over the upper end. Very nice. The price on these boots is very attractive and the quality seems good, so I think you will enjoy owning a pair. :: Paul, 02-19-13

Happy Customers Who Bought This Product

Motoboots
From: carlos r.
Location: Florida

Nice boots, also comfortable to walk during trip stops. They look like short outside but they are roomy inside. Good boots. (Read more...)

First_gear_kili_low_boot
From: Richard K.
Location: California

I've had these First Gear low mesh boots for only a couple of weeks but worn them many times and they are great. They really do flow a good amount of air in our hot desert weather. They were very comfortable right out of the box and are very good ... (Read more...)

New Enough is now MotorcycleGear.com